( 4 )
1. Unscrew the outside
FADER PLATE SCREWS (B)
.
Do not touch the
INSIDE SCREWS (C).
2. Carefully lift the fader and unplug the
CABLE (D)
.
3. Plug the new fader into the cable and place it back in
the mixer.
4. Screw the fader to the mixer.
7.
OUTPUT CONTROL SECTION:
The level of the
MASTER
OUT (31)
is controlled by the
MASTER (23)
slide. The
Master
TREBLE (20)
and
BASS (21)
controls allow you to
adjust the output of channels 1-4.
NOTE: THE RECORD OUT (27) HAS NO LEVEL
CONTROL. THE LEVEL IS SET BY THE CHANNEL
SLIDES OF THE SELECTED CHANNEL.
8.
TALKOVER SECTION:
The purpose of the talkover section
is to allow the program playing to be muted so that the
MIC
can be heard above the music. The
MIC 1/TALKOVER
SWITCH (6)
controls
MIC 1
and has three settings. When
the
MIC 1/TALKOVER SWITCH (6)
is in the bottom
position, the
MIC
and talkover are off. When the
MIC 1/
TALKOVER SWITCH (6)
is in the center position
MIC 1
is
on, the
MIC 1 INDICATOR (7)
will glow, but talkover is off.
When the
MIC 1/TALKOVER SWITCH (6)
is in the top
position,
MIC 1
and talkover will be on and the volume of all
sources except the
MIC
input are lowered by 16dB. The
MIC LEVEL (16)
controls the level of
MIC 1
.
9.
CUE SECTION:
By connecting a set of headphones to the
HEADPHONE (5)
jack, you can monitor any or all of the
channels. Press the
CUE ASSIGN (19)
buttons for
channels
1-4
to select the channel or channels to be
monitored and their respective
LED
indicators will glow.
Use the
CUE LEVEL (24)
control to adjust the cue volume
without effecting the overall mix. By moving the
CUE
PGM PAN (22)
control to the left you will be able to monitor
the assigned cue signal. Moving the control to the right will
monitor the
PGM (program)
output.
10.
DISPLAY:
The
DISPLAY (18)
indicates the
MASTER
output left and right levels.
SPECIFICATIONS:
INPUTS:
MIC 1..............................................1.5mV 2kOhm balanced
MIC 2 ............................................1.5mV 2KOhm balanced
Phono @ 1kHz...............................................2mV 47kOhm
Line...........................................................100 mV 27kOhm
OUTPUTS:
Amp/Booth................................................0 dB 1V 400Ohm
Max....................20V Peak to Peak
Rec..............................................................225mV 5kOhm
GENERAL:
Bass....................................................................... ± 12dB
Treble......................................................................± 12dB
Frequency Response..........................20Hz - 20KHz +/- 2dB
Distortion....................................................less than 0.02%
S/N Ratio...................................................better than 80dB
Talkover Attenuation....................................................-16dB
Power Source:............................Adapter-115V/15V AC 0.5A
..........................................................or 230V/15V AC 0.5A
Dimensions..................19”w x 3”d x 7”h (483 x 76 x 178 mm)
Weight.......................................................6.25lbs (2.84 kg)
Summary of Contents for PMX-1100
Page 11: ... 11 NOTES ...