Gemini SA-2400, Operation Manual

Page 6

PITCH BEND:

1. Pushing the PITCH BEND (23) buttons will temporarily raise or lower

the pitch without changing the slide setting. Releasing the buttons will
return the pitch to the slide setting.

USING THE REVERSE BUTTON:

1. Press the REVERSE (30) button to reverse the rotation of the PLATTER

(2) (the REVERSE LED (30A) will light while in reverse mode). Press
the REVERSE button a second time to return to normal play.

DIGITAL DISPLAY:

1. The DIGITAL DISPLAY (20) indicates SPEED (20A), PITCH SLIDE

ACTIVATION (20B), PLAY (20C), PAUSE (20D), REVERSE (20E) and
PITCH PERCENTAGE (20F).

ARM-LIFT HEIGHT ADJUSTMENT:

If the pre-adjusted distance that the CUE LEVER (19) raises the stylus off
the record surface is inadequate, it can be adjusted by turning the ARM-
LIFT HEIGHT ADJUSTMENT SCREW (29) while simultaneously pushing
down on the TONE ARM (6).  Clockwise rotation of the screw will decrease
the distance and counterclockwise rotation will increase the distance.

Specifications

TURNTABLE SECTION:

Type...................................................Quartz Direct Drive Manual Turntable
Drive Method................................................................................Direct Drive
Motor......................................................................Brushless DC Motor 18V
Platter............................................Aluminum Diecast  13”  (332mm) Dia.
Speed...............................................................................33 1/3, 45 or 78 RPM
Starting Torque..............................................................................2.2 kg/cm
Build-up Characteristics...........................0.6 sec. standstill to 33 1/3 RPM
Braking System....................................................................Electronic Brake
Wow and Flutter.....................................................................0.01% WRMS*
* This rating refers to the turntable assembly and platter only and excludes
effects of records,  cartridges or tonearms.

Rumble........................................................................78 dB (IEC 98A WTD)

TONEARM SECTION:

Type...........................................................Universal Straight Tubular Arm
Effective Length.............................................................9 1/16” (231.5 mm)
Arm Height Adjust Range...............................................................0 - 6 mm
Overhang............................................................................19/32" (15.1 mm)
Effective Mass..............................................................9 g (Without Cartridge)
Offset Angle...............................................................................................22°
Friction..................................................Less Than 7 mg (Lateral, Vertical)
Tracking Error Angle............Within 2°32' at the outer groove  and within

0°32' at the inner groove of a 30 cm (12") record

Stylus Pressure Adjust Range..........................................................0 - 5 g
Applicable Cartridge Weight Range.................................................6 - 10 g
Headshell  Weight.................................................................................9 g

GENERAL:

Power Supply...............................................................115V~60Hz/230V~50Hz
Power Consumption..........................................................................15 Watts
Dimensions......................................................................17 3/4” x 6" x 14"

450mm x 152mm x 352 mm

Weight......................................................................................27 lbs. (12.3 kg)

Specifications are subject to change without notice. The weight and dimensions
shown are approximate.