Jewelry Sauna Manual
13
WHEN IT BECOMES NECESSARY TO REFILL STEAMER
1.
Turn the unit off by flipping the power switch located on the
rear center bottom of the Jewelry Sauna to the “0” position.
2. Unplug it from the power outlet.
3. With the steam shield down, remove the ultrasonic basket.
4. You must first drain the ultrasonic tank by lifting
the appliance by holding both sides of the unit
and position it over a sink.
DO NOT LIFT THE
UNIT BY ITS STEAM ACTIVATION LEVER.
5. Tilt the appliance to the side, and in a quick motion
pour the water from the ultrasonic tank into the sink.
6. If the steam tank is hot, allow sufficient cooling time
of approximately 30 minutes prior to refilling the
tank. As a safety feature, the white fill cap cannot
be removed until it has sufficiently cooled.
7. While maintaining an arm’s length distance from the
Jewelry Sauna slowly unscrew the white fill cap.
8. As you are unscrewing the fill cap the remaining pressure
if present will release from around it. Press down on
the steam activation lever to more quickly release the
remaining steam in its tank. Remove the white fill cap.
9. IMPORTANT: Before refilling the steamer tank, you must
first fully drain any remaining water in its tank so as not
to overfill it.
WARNING: OVERFILLING THE STEAMER
TANK WILL PRODUCE A POTENTIALLY HAZARDOUS
SPUTTERING OF WATER AND WET STEAM UNTIL THE
WATER LEVEL IN THE STEAMER TANK HAS BEEN
REDUCED TO THE CORRECT LEVEL SO STEAM MAY BE
PRODUCED.
While holding the appliance over the sink,
tilt the appliance backwards and hold it upside down to
drain any remaining water that may still be in the tank.
10. Fill the measuring cup with water to the indicated
4.5oz mark (4.5oz + 4.5oz fill cups maximum
water capacity). Place the funnel in the water
fill hole where the fill cap was positioned.
11. Slowly pour water it into the funnel opening.
Always be certain to dry any excess water within
the funnel area before replacing the cap.