Jewelry Sauna Manual
9
6. With the steam shield down and the ultrasonic basket
removed, insert the funnel into the ultrasonic tank. While
holding the funnel in place, pour water into the tank
and fill it to the MAX fill mark noted in the rear of the
ultrasonic tank. For enhanced cleaning, add a Sparkle Pak
Plus ultrasonic cleaning solution packet to the water.
7. Insert the ultrasonic basket into the ultrasonic tank
while being certain to properly position the edge
of the basket onto the lip of the steam shield.
8. Plug the Jewelry Sauna into a grounded electrical outlet.
9. Flip the switch located on back side of the
Jewelry Sauna from the “O” mark to the “|” mark.
The Steam Power indicator will illuminate.
10. Remove the tweezers from the top storage compartment.
HOW TO USE THE JEWELRY SAUNA
1.
A
Place jewelry into the basket and insert the
basket into the full ultrasonic tank while resting the
edge of the basket on lip of the steam shield.
2.
B
Press the Ultrasonic Timer button repeatedly
to scroll to the available cleaning times of 180
and 360 seconds (3 and 6 minutes).
3. Once the desired cleaning time has been determined,
please note that there is a delayed time of
approximately 3 seconds before the ultrasonic will
automatically begin operating.
Depending on the
amount of dirt on the jewelry, repeating this cycle
may be necessary to achieve the desired results.
4. When the ultrasonic cleaning cycle has ended, while
using your fingers to apply a downward pressure on
the top of the Jewelry Sauna for leverage,
C
grasp the
bottom horizontal lifting handle on the steam shield and
slide it up until it firmly locks into place to the rim of the
steam chamber.
IMPORTANT: When the steam shield
is securely locked into place you will hear a “clicking
sound” indicating that it has been closed correctly.
5.
D
Press the steam lever down repeatedly to apply 1-2
second bursts of steam to the jewelry in the basket.
Typically, all that is required is to do this 3-4 times.
