P-780 User’s Guide v1.2
February 7, 2005
Gemtek Systems
Page 26 of 60
Figure 14 – Interface Configuration Table
To change network interface (bridge) configuration properties click the
Edit
button in the
Action
column. The
status
can be changed now:
Figure 15 – Edit Interface Configuration Settings
IP Address
- specify new interface IP address [in digits and dots notation, e.g. 192.168.123.70].
Netmask
– specify the subnet mask [[0-255].[0-255].[0-255].[0-255]].These numbers are a binary
mask of the IP address, which defines IP address order and the number of IP addresses in the subnet.
Gateway Address
– interface gateway. For Bridge type interfaces, the gateway is always the
gateway router.
Protocol
– specify
static
for setting IP address manually and
dhcp
for getting IP address dynamically
acting as DHCP client.
When
dhcp
is used for getting IP address, Kickstart is recommended to find your
device.
Save
– save the entered values.
Cancel –
restore all previous values.
Change status or leave in the default state if no editing is necessary and click the
Save
button.
Figure 16 – Apply or Discard Interface Configuration Changes
Apply
Changes
– to save all changes in the
interface
table at once.
Discard Changes
– restore all previous values.
For such each change of settings, the P-780 needs to be restarted to apply all settings changes when
clicking
Apply
Changes
. Request for reboot server appears:
Figure 17 – Reboot Server
Reboot
– Click the button to restart the server and apply the changes.