background image

WARNING! 

 

Gendron  recommends  that  users  not  be  transported  in  vehicles  while  seated  in  the 
wheelchair.    We  do  not  approve  of  any  tie-down  system  for  transportation  of  users  in  any 
moving vehicle while seated in the wheelchair.

 

 

Do not tilt the wheelchair back when occupied. This may cause serious injury to wheelchair 
user or assistant.

 

 

Do not attempt to go up or down steps.

 

 

Do not ride over curbs or obstacles.  This may cause the wheelchair to become unstable and 
cause bodily harm to you or damage the wheelchair. Always use curb cuts.

 

 

Do not use your chair on a slope grade steeper than 10%.  (A 10% slope grade means one 
foot in elevation for every ten feet of slope length.)

 

 

Do not park the wheelchair on an incline.

 

 

Do not operate the wheelchair on slippery surfaces.

 

 

Do not lift the wheelchair by any removable parts including armrests and footrests.  Lifting the 
wheelchair by these parts, occupied or not, may damage the wheelchair.

 

 

Do not stand on footrests.  When entering and exiting chair always fold up footrests.

 

 

Do not move forward in  seat to reach for objects.  Do not pick objects up from the floor by 
reaching down between your knees.

 

 

Do not lean over the top of the back upholstery.

 

 

The  back  height,  caster  position,  rear  wheel  position,  and  anti-tip  position  all  define  the 
stability of the wheelchair. Any of these setting changes must be done in accordance with the 
descriptions in this manual.

 

 

When opening or preparing the wheelchair to use, do NOT grab side seat tubes with fingers 
underneath. This could pinch fingers between seat rest tubes and the seat tube rest.

 

 

Before sitting in wheelchair to use, 

 

               First, lock both wheel brakes   
               Second, place hands on arm rests, do NOT place hands in corners of wheelchair  

                    

                             

NOT this way

 

Summary of Contents for Regency XL 2000









Reviews: