Edificio Genebre. Av. de Joan Carles I, 46-48
08908 L'Hospitalet de Llobregat. Barcelona (Spain)
genebre@genebre.es - www.genebre.es
GENEBRE S.A.
FECHA DE REVISIÓN: 16/03/2020 NUMERO DE REVISIÓN: 1
7
To convert a standard (ON-OFF) J4C electric actuator into a modulating function with
positioner, proceed as follows:
6.2 Remove the hand wheel:
•
Remove the screw, which are fixing the hand wheel (Fig.2):
6.3 Remove the 6 screws, which are fixing the body to the cover of actuator and remove
carefully it (Fig.3 y 4):
6.4 Remove the cables (from the cover) connected to the actuator (Fig.5A,B,C):
VERY IMPORTANT NOTICE: The unit must be disconnected from any
electrical power or signal before installing.
