Genebre Building. Av. de Joan Carles I, 46-48
08908 L'Hospitalet de Llobregat. Barcelona (Spain)
genebre@genebre.es - www.genebre.es
GENEBRE S.A.
UPDATE DATE: 07/07/2020 UPDATE NUMBER: 1
5
•
Maximum pressure of air supply 7 bar (100 PSI)
6. Positioner Installation
6.1 Installation of the Support and the Positioner on the actuator
•
Connection to the fixing of the output shaft in which the position of the
positioner’s output shaft and the main shaft of the rotating actuator are
concentric. Type C connection (see figure) is Namur, direct connection to the
actuator.
•
The positioner’s support is designed to be mounted on actuators with a shaft
height of H=20 or H=30, as well as fixing holes at 80 mm or 130 mm according
to Namur regulations.
6.2 Mounting of the Cam
Attention: Do not supply air to the equipment during this operation. It
may be highly dangerous.
Make sure the supply air to be used is Dry, Clean and Filtered, since
bad quality supply air may seriously damage the positioner.
