Genebre Building. Av. de Joan Carles I, 46-48
08908 L'Hospitalet de Llobregat. Barcelona (Spain)
genebre@genebre.es - www.genebre.es
GENEBRE S.A.
UPDATE DATE: 07/07/2020 UPDATE NUMBER: 1
6
Note: The positioner leaves the factory with the cam mounted on the shaft and the
indicator p
late in the position “RA” (counter-clockwise/reverse acting).
In case you need to switch the direction (clockwise/direct acting) proceed as follows:
•
Lift the cover of the positioner.
•
Remove the clamping screw from the indicator plate and remove the plate.
•
Remove the clamping nut from the cam.
•
Remove the cam and turn with the side marked as “DA” facing up.
•
Mount the cam on the ledge of the output shaft.
•
Set the actuator on the initial position.
•
Fix the cam using the upper n
ut so that the reference line “0” is tangent to the
bearing.
•
Once the cam is mounted, place and fix the indicator plate to the main shaft using
the M3 screw so that the reference lines for the cam and the indicator match up.
6.3 Air Connection.
Attention: Make sure the supply air to be used is Dry, Clean and
Filtered.
