101
User
Manual
GWG Gateway
parameters necessary for connection configuration should be required from mobile operator.
•
Check the status of GSM/UMTS/LTE connection (
Mobile Settings
Tab). If disconnected please click
Connect
button.
•
Click
VPN Settings
>
GRE
to configure GRE tunnel parameters:
•
Enable: yes,
•
Local Tunnel Address: 10.10.10.2
•
Local Tunnel Netmask: 255.255.255.252 (Unchangeable, always 255.255.255.252)
•
Tunnel Source: 1. 10.251.49.3 (obtained by the network provider )
2. Select HOST from drop down menu if you want to use host name as peer
identifier
•
Tunnel Destination: 1. 10.251.49.2 (obtained by the network provider )
•
2. Select HOST from drop down menu if you want to use host name
as peer identifier
•
KeepAlive enable: no,
•
Period:(none),
•
Retries:(none),
•
Press ADD to put GRE tunnel rule into GRE table,
•
Press
Save
to accept the changes.
Figure
77
– GRE configuration page for GWG Gateway 2
•
Configure GRE Route. Click
Static Routes
on
Routing
Tab. Parameters for this example are:
•
Destination Network: 192.168.4.0,
•
Netmask: 255.255.255.0.
•
Interface: gre_x.
Figure
78
– Routing configuration page for GWG Gateway 2
Summary of Contents for GWG
Page 1: ...GWG Gateway USER MANUAL GWG Document version 1 0 1 Date July 2016 WWW GENEKO RS ...
Page 43: ...43 User Manual GWG Gateway Figure 22 RIP configuration page ...
Page 136: ...136 User Manual GWG Gateway Click OK Figure 125 Policies from trust to untrust zone ...
Page 156: ...156 User Manual GWG Gateway Figure 150 Configuration page for SIM keepalive ...