50
User
Manual
GWG Gateway
Connection mode
Field displays connection mode of the current tunnel.
Log level
Set IPSec log level.
Add New Tunnel
Click on this button to add a new Device–to–Device IPSec tunnel. After you have
added the tunnel, you will see it listed in the Summary table.
Start
This button starts the IPSec negotiations between all defined and enabled tunnels. If
the IPSec is already started, Start button is replaced with Restart button.
Stop
This button will stop all IPSec started negotiations.
Refresh
Click on this button to refresh the Status field in the Summary table.
Table
12
– IPSec Summary
To create a tunnel click Add New Tunnel button. Depending on your selection, the Local Group
Setup and Remote Group Setup settings will differ. Proceed to the appropriate instructions for your
selection.
Summary of Contents for GWG
Page 1: ...GWG Gateway USER MANUAL GWG Document version 1 0 1 Date July 2016 WWW GENEKO RS ...
Page 43: ...43 User Manual GWG Gateway Figure 22 RIP configuration page ...
Page 136: ...136 User Manual GWG Gateway Click OK Figure 125 Policies from trust to untrust zone ...
Page 156: ...156 User Manual GWG Gateway Figure 150 Configuration page for SIM keepalive ...