Subwoofer in consumer Sur
Subwoofer in consumer Sur
Subwoofer in consumer Sur
Subwoofer in consumer Sur
Subwoofer in consumer Surrrrrround Sound
ound Sound
ound Sound
ound Sound
ound Sound
configuration.
configuration.
configuration.
configuration.
configuration.
When using the 1029A in a surround sound system with
the 1091A the "bass roll-off" switches on the 1029A should
be set to -6dB. The centre channel on the decoder should
be set to "wide band", "large", or "full range" mode.
Subwoofer in two channel Ster
Subwoofer in two channel Ster
Subwoofer in two channel Ster
Subwoofer in two channel Ster
Subwoofer in two channel Stereo
eo
eo
eo
eo
configuration.
configuration.
configuration.
configuration.
configuration.
Both left and right stereo channels are fed into the
corresponding monitor. Each monitor output is then con-
nected to the subwoofer. It should be noted that the
subwoofer should only be placed at the end of the signal
chain. Never use the 1091A as a loop-through device.
The figure to the left shows some example subwoofer positions within a
room.
1
Recommended position.
2
This arrangement may cause a loss in low frequencies if the
distance from the subwoofer position to any wall is between
1 and 3m. This position may be available beneath a mixing
console or desk.
3
Recommended only when using two subwoofers.
The following diagrams show various ways the subwoofer can easily be included into an existing system. All connections
to the subwoofer should be of the balanced XLR type to maintain the noise immunity of the speaker system. The output of
the 1029A is of the balanced type.
W
W
W
W
Wiring diagram for inter
iring diagram for inter
iring diagram for inter
iring diagram for inter
iring diagram for interconnects.
connects.
connects.
connects.
connects.
The diagram to the left shows how to make the required
cables for the system. The connections to the subwoofer
are always balanced. One of each type of cable is
required.
Subwoofer positioning.
Subwoofer positioning.
Subwoofer positioning.
Subwoofer positioning.
Subwoofer positioning.
System Configurations.
System Configurations.
System Configurations.
System Configurations.
System Configurations.
3
1
3
2
ON
GENELEC
ON
GENELEC
ON
GENELEC
2 CHANNEL
STEREO
SOURCE.
MONITOR LEFT
MONITOR RIGHT
O/P LEFT
O/P RIGHT
1091A SUBWOOFER
ON
GENELEC
INPUT 1
INPUT 1
SUB OUT
SUB OUT
INPUT 1
INPUT 2
ON
GENELEC
SURROUND
SOUND
PROCESSOR
ON
GENELEC
ON
GENELEC
ON
GENELEC
ON
GENELEC
ON
GENELEC
ON
GENELEC
SIDE RIGHT
REAR
RIGHT
REAR
LEFT
SIDE LEFT
FRONT
RIGHT
FRONT
CENTRE
FRONT
LEFT
SUB
OUT
INPUT 1
1091A SUBWOOFER
2
1
3
SCREEN
CABLE
1/4" JACK
XLR
MALE
1
2
3
SCREEN
CABLE
1/4" JACK
1
2
3
1
2
3
1/4" JACK
