Generac Portable Products 2200 PSI High Pressure Washer
7
Add Engine Oil
WARNING!
Any attempt to crank or start the
engine before it has been properly serviced
with the recommended oil will result in an
engine failure.
Use only high quality detergent oil rated with API
service classification SF or SG rated 10W30. Do
not use SAE 10W40 oil.
Place the pressure washer on a level surface.
Clean the area around oil fill and remove the oil
dipstick (Figure 2).
Wipe the dipstick clean.
Insert and remove the dipstick without screwing it
into the filler neck. Check the oil level shown on the
dipstick.
If the oil level is low, fill to the edge of the oil filler
hole with the recommended oil. DO NOT
OVERFILL.
Reinstall the oil dipstick, hand tighten securely.
Note: Check Oil Often During Engine Breakin.
Add Gasoline
DANGER!
Never fill fuel tank indoors. or
when engine is running or hot.
Do not smoke
when filling fuel tank.
WARNING!
Always fill tank to about 1/2"
below the bottom of the filler neck to provide
space for fuel expansion. Wipe away fuel
spillage before starting engine.
Use clean fuel and store in approved, clean
covered containers. Use clean fill funnels. Never
use stale gasoline left over from last season or
gasoline stored for long periods.
Clean the area around the fuel fill cap, remove the
cap (Figure 3).
Add
regular UNLEADED gasoline
, slowly, to fuel
tank. Use a funnel to prevent spillage.
Install the fuel cap and wipe up any spilled
gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT:
You must assemble the wand and
attach all hoses before you start the engine. Starting
engine without all hoses connected and water
supplied will damage the pump.
Uncoil the high pressure hose and attach one end
of the hose to the base of the spray gun.
(Figure 4). Tighten by hand.
Figure 2 Add Oil to Engine Crankcase
Oil Fill Cap/Dipstick
Upper Limit
Lower Limit
Figure 3 Add Regular Unleaded Gasoline to Fuel
Tank.
Figure 4 Connect High Pressure Hose to Fuel Tank
Connect high pressure
hose here.
