16
Owner’s Manual for Chipper/Shredder
Maintenance
Changing Engine Oil
WARNING
(000415)
Accidental start-up. Before servicing or detangling, shut
down unit, allow to cool, remove keys, and disconnect spark
plug wire(s). Failure to do so could result in death, serious
injury, or equipment damage.
(000139)
WARNING
Risk of burns. Allow engine to cool before
draining oil or coolant. Failure to do so could
result in death or serious injury.
(000210)
WARNING
Skin irritation. Avoid prolonged or repeated contact with
used motor oil. Used motor oil has been shown to cause
skin cancer in laboratory animals. Thoroughly wash
exposed areas with soap and water.
(000135)
Engine damage. Verify proper type and quantity of
engine oil prior to starting engine. Failure to do so
could result in engine damage.
CAUTION
NOTE:
Drain oil when engine is warm. Warm oil drains
more completely.
1.
Set the machine on a level surface.
2.
Place a suitable container under the right side of
the unit between the wheels.
3.
See
. Remove oil fill/dipstick (A) located
on the left side of the machine.
A
010548
Figure 4-1. Engine Oil Fill Location (left side)
4.
See
. Remove drain plug (B) with a 10
mm wrench and allow used oil to drain through
drain hole (C) and into waste container.
NOTE:
Allow oil to drain completely.
B
C
010549
Figure 4-2. Engine Oil Drain Hole and Plug
(right side)
5.
Install oil drain plug.
6.
Fill with recommended oil. See
.
7.
Install oil dipstick/fill cap.
Greasing Wheel Bearings
1.
See
. Wipe all dirt from grease fittings
(A) on both wheel.
A
010550
Figure 4-3. Greasing Wheel Bearings
2.
Apply no more than three pumps of quality general-
purpose lithium grease with a hand-pumped
grease gun to the grease fitting on each wheel.
Summary of Contents for GC3000C
