7
NOTE:
The magnets in the display unit activate a magnetic reed switch
in the generator transceiver in step 21. The relative positioning
of the two units needs to be as shown in Figure 10 to activate
the magnetic reed switch.
Figure 11 – Location of Pair/Reset Button
25. Proceed with the “Re-Assemble the Generator” section
26. If the two modules fail to pair up within 30 seconds, the yel-
low LED will stop flashing and the red LED will begin to flash.
If this happens proceed as follows:
• Press and release the Pair/Reset button to stop the red LED
from flashing.
• Check that good non-rechargeable AAA 1.5V batteries are
installed.
• Check the wiring to make sure all the plugs are fully
inserted.
• Repeat the pairing process from step 21A.
RE-ASSEMBLE THE GENERATOR
27. Open the top lid of the generator.
28. Remove the 7.5 Amp control panel fuse.
29. If needed, use tie wraps to secure the new wire harnesses.
30. Replace the plastic cover over the customer connect termi-
nals.
31. Replace the control panel cover and retaining screws.
32. Replace the front access panel.
33. Replace the 7.5 Amp control panel fuse.
34. Set the Auto/Off/Manual switch to the Auto position.
35. Close the top lid of the generator.
Information Label
A write on label has been provided for adding the generator serial
number and dealer information for easy reference (Figure 12.)
Figure 12 – Information label
DISPLAY UNIT MOUNTING
The display unit has two internal magnets allowing it to be eas-
ily attached to any magnetic surface such as a refrigerator. The
display unit also has two mounting holes in the back which can
be used to mount it to a wall. See figure 13 for mounting hole
locations.
Figure 13 – Mounting hole locations
13
NOTE:
The display unit is intended to be mounted indoors only. Avoid
mounting the display unit in wet or damp locations.
Wireless Display System
Pair/Reset
Button
