Generac Power Systems Trimmer/Mower, Owner'S Manual

Owner’s Manual for Trimmer/Mower™

13

Maintenance and Troubleshooting

3.

See 

Figure 4-5

. For the highest trimmer setting,

install the quick lock with adapter (C), followed by
both spacers (B) onto the shaft.

4.

Place Mow-Ball® bolt into the hex cavity of Mow-
Ball (A).

5.

While holding the Mow-Ball bolt head in place turn
Mow-Ball counterclockwise to start the bolt onto
the shaft.

6.

Continue turning the Mow-Ball until tight. 

Figure 4-5. Highest Cutting Height Setting

Maintaining Cord Head

1.

See 

Figure 4-6

. Remove Mow-Ball (A), quick lock

with adapter (B), and molded spacers (C) from
shaft. Do not remove anti-wrap canister. See

Quick Lock Head Disassembly

.

Figure 4-6. Cord Head Disassembly

2.

See 

Figure 4-7

. Remove the four screws (E) secur-

ing line plates (F) together with a 3 mm Allen wrench.

Figure 4-7. Cord Head

3.

See 

Figure 4-8

. Remove springs (G) and locking

cams (H) from the middle and bottom plates and
clean any grass or debris from springs and cams.

Figure 4-8. Springs and Locking Cams

4.

Clean all plates using a nylon brush and clean rag.

5.

Inspect springs and cams for damage. If any parts
are damaged, contact Generac Customer Service
at 1-888-436-3722 (1-888-GENERAC), or

www.generac.com

 to order a replacement.

6.

Reinstall springs and locking cams and verify
springs and cams are seated fully into plate grooves.

7.

See 

Figure 4-9

. Assemble the plate and verify the

plates align properly. The four screw holes on top
must align and cutouts (I) should align from plate to
plate on the sides.

Figure 4-9. Plate Assembly

006360

D

A

B

C

WARNING

Personal injury. Verify all tools have been removed 
from unit after service. Failure to do so could result 
in personal injury or equipment damage

.

(000491)

006359

A

B

C

005973

E

F

006362

G

H

006363

I

I