Integrated L-Band Up/Dn Converter
LT3600
CG-1309
Page 8
1.8 Part Number Configuration
The Part Number Selection Chart shows configuration options that are set at the factory prior to
shipment. The voltage output to J4 and J10 may be changed as required by the customer, however
this requires removal of the cover and resetting internal jumper connections. This should be
performed by qualified personnel.
1
st
Digit
2
nd
Digit
3
rd
Digit
4
th
Digit
Base
Number
IF Operation
L-Band
Bias Voltage
Ref. Oscillator
201667 - 1
70 MHZ
1
Std.
0
None
0
Std 10Mhz
2 140
MHz 2 Extend 1 D/C-22VDC
U/C-22VDC
1 Hi
Accuracy
10 MHz
2 D/C-22VDC
U/C-15VDC
5
th
Digit
6
th
Digit
7
th
Digit
L-Band Ports
10 MHZ Ref. Out
StarSwitch Ready
0
SMA Female
0
No Output
0
No
1
N-Type Female
1
U/C & D/C
1
Yes
2
U/C
Only
3
D/C
Only
Note: If connected to a StarSwitch, No Bias Voltage Output is allowed.
Option Descriptions:
1
st
Digit – IF Frequency, Options 3 and 4 are set for inverted spectrum.
2
nd
Digit – Standard – 950 to 1525 MHz, Extended – 950 to 1950 MHz
3
rd
Digit – Bias voltage outputs are switchable in rear panel, if selected.
4
th
Digit – A reference oscilator is built in to the main board. The high accuracy unit is optional.
5
th
Digit – D/C Input and U/C Output Port Type (J4 & J10)
6
th
Digit – The output from the 10 MHz reference oscilator may be connected to either or both.
7
th
Digit – StarSwitch Ready includes output connections to J5 and J8 for control between the
Starswitch and the LT3600.
