P.5
4. Position your engine onto the engine mount.
With the engine resting on the engine mount rails.
Center the engine and engine mount. Then tighten
the engine mount bolts. With your engine still resting
on the rails, position the engine so that the distance
from the firewall to the front of the engine thrust
washer is 145mm. With the engine properly
positioned, resting on the engine mount, slide the
cowl onto the fuselage to be sure the engine is
extending out of the cowl far enough.
5. Using the engine as a guide, mark the four holes
for the engine bolts on the engine mount. Install the
engine onto the engine mount. Drill four holes in
the mount. Drill four holes in the mount. Then, use
a tap to thread the holes.
INSTALL FUEL TANK
INSTALL FUEL TANK
Assemble the fuel tank as shown in the sketch. When
tightening the center screw be sure not to over
tighten it. You just want it snug enough to pull the
rubber stopper tight against the tank.
Hold the tank in place inside the fuselage by two
rubber banks around the tank, attaching the banks
to the tabs in the plywood former that supports the
tank.
160mm/6.3in
INSTALL THE COWL
INSTALL THE COWL
1. Place the cowl in position on the fuselage.
Making sure the engine is centered in the
opening in the front of the cowl.
STICK THE WINDOWS
STICK THE WINDOWS
Examine the side of the fuselage, there are small
rooms you need to cut off the covering. These small
rooms are like the windows of plane. You may find
some plastic board in your parts bag.
Stick these plastic board on the slots you just cut
off inside the fuselage.
C I T A B R I A - 1 2 0
C I T A B R I A - 1 2 0
