General International 15-030 M1, Setup & Operation Manual

CONVEYOR MOTOR SWITCH WITH SAFETY KEY

SAFETY KEY*

ON

* 

PREVENTS START-UP WHEN REMOVED

OFF

This model 15-030 is also equiped with a simple ON/OFF
switch for the conveyor motor, featuring a removable
lock out safety key.

To start the conveyor belt, insert the safety key,

, and

lift the switch up,

. To stop the machine, push the

switch down,

.

To prevent unauthorized use or unintentional start-up,
remove the safety key and store it in a safe place
whenever the sander is not in use.

REMOVE THE SWITCH KEY AND STORE IT IN A SAFE PLACE, OUT OF THE REACH OF CHILDREN, WHENEVER THE SANDER IS
NOT IN USE.

OVERLOAD PROTECTION

The magnetic safety switch on this sander is equipped with an overload protection feature. To prevent an electrical
overload from damaging the motor, in the event of a spike in line voltage or amperage draw, the internal overload
protector will automatically be tripped, thereby cutting off power to the motor.

Note: The most common causes of such overloads are:

1.

Overworking the motor by attempting to remove too much material in a single pass, thereby causing an increase in 
power consumption and a spike in amperage draw.

2.

An electrical extension cord that is too long or not the correct gauge of wire, which can also cause an increase in 
amperage draw. If an electric extension cord must be used, follow the instructions and refer to the chart in the electri-
cal requirements section at the beginning of this manual.

3.

Overworked circuit caused by operating on a circuit that is close to its amperage draw capacity. Make sure the cir-
cuit being used is capable of handling the amperage draw from this machine as well as any other electrical devices 
operating on the same circuit. If you are unsure, consult a qualified electrician.

To reset the overload protection switch after it has been tripped proceed as follows:

TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP BE CERTAIN THAT BOTH OF THE POWER SWITCHES HAVE BEEN SET TO
THE OFF POSITION BEFORE RE-SETTING THE OVERLOAD PROTECTION SWITCH.

1.

Set both of the the power switches on the sander to 
the off position and disconnect the machine from 
the power source.

Note:  If the sander is permanently connected to a circuit
(hard-wired), set the wall panel circuit breaker or main cir-
cuit interrupter to the off position.

2.

Unscrew the 2 screws

and remove the control 

box front cover then press the red reset button 

.

3.

Reinstall the control box cover.

4.

Reconnect the sander to the power source.

5.

You can now restart the sander by pushing on  the 
green button ON.

SWITCHES OFF

13