INSTALLING THE SPLASH GUARDS
1.
Loosen the two screws already installed on the
back of the machine with a 6 mm Allen key.
INSTALLING THE SUPPORT ROLLER
1.
Remove the two screws and flat washers on the left
side of the machine with a 6 mm Allen key.
2.
Align the roller slots with the holes in the machine
and secure it in place with screws and washers.
Note: To adjust the support roller height as needed
along the slotted mounting holes.
2.
Slide a splash guard onto the two screws and be-
hind the flat washers. Retighten the two screws, then
repeat with the other splash guard on the front of
the machine.
16
INSTALLING THE FRONT PLATE
1.
Remove the four screws installed at the bottom
front of the stand using a 3 mm Allen key.
2.
Align the plate mounting holes with the holes in the
base, then attach it with the four screws.
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.