19
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
5.
Make sure the pointer is aligned with the 45° marker
when the saw head is turned all the way to the right
or left. To re-align the pointer, go to the next step.
6.
Loosen the left stop with a 5 mm Allen key, then ad-
just the stop along its slotted hole until the pointer
is aligned with the 45° mark. Repeat with the right
stop.
LEFT STOP
RIGHT STOP
ADJUSTING AND USING THE VISE
1.
Position the workpiece in the vise and secure it in
place using vise handwheel
D
.
2.
Lock the workpiece in place turning the quick lock-
ing lever to the left as shown.
3.
If the lever does not lock the base properly, loosen
the screw
A
with a 6 mm Allen key while holding the
lever in place on its shaft.
4.
Turn the lever to the right, and then retighten the
screw
A
. Make sure the lever locks the swivel base.
If not, repeat steps
3
&
4
.
A
ADJUSTING THE SWIVEL BASE (CONTINUED)
D