General International 857647 005161, Operating Manual

English

27.  The Compressor operates automatically while the 

motor is turned on.

28.  Compressed air from the unit may contain carbon 

monoxide. Air produced is not suitable for breathing 
purposes.

29.  Always use a respirator when spraying paint or 

chemicals.

30.  The air pressure switch is set at the factory for 

optimum performance of your equipment. Never 
attempt to bypass or remove this switch as serious 
damage to equipment or personal injury could result 
from excessive air pressure.

KNOw YOUR COMPRESSOR

Air Regulator: 

The air regulator controls the air 

flow pressure. Turn regulator clockwise to increase 
air pressure, counter-clockwise to decrease air 
pressure.

Air Chuck:

 Convenient quick disconnect air chuck 

allows for fast easy connection to an air hose.

Tank Drain Valve:

 The Tank Drain Valve can be 

opened to allow moisture and compressed air to be 
released from the Air Tank.

Power Switch:

 The red power switch turns the air 

compressor on and off. 

Note:

  Always make sure that compressor Power 

Switch is in the OFF position before 
performing any maintenance or plugging the 
compressor into a power supply.

Pressure Gauges:

 These dual gauges indicate the 

amount of air pressure built up in the air tank, as 
well as the air pressure being delivered to the air 
chuck.

Safety Valve:

 The Safety Valve device relieves 

pressure from the Air Tank in the event of excessive 
pressure build up. The Safety Valve is preset at 
factory. Do not attempt to make any adjustments to 
the Safety Valve. Periodically pull ring on the Safety 
Valve end to check that it is working properly.

Air Tank:

 Powder coated steel tank stores the 

compressed air until it is needed.

GETTING STARTEd

Before operating your tool, check the contents of 
the box to make sure you have everything you will 
need. 

Items included in the box:
 

Air Compressor

Air Chuck

Wheels (2)

Mounting Hardware for Wheels

Owner’s Manual

ASSEMBLY

NOTE:

 Before performing any assembly or 

maintenance make sure compressor is turned off 
and unplugged from the power supply.

Installing the Wheels

1.   Locate the wheels, hex bolts, washers, and 

wheel nuts.

2.   Insert hex bolt through center hole in wheel rim.
3.   Insert the hex bolt, with wheel in place, through 

the hole located in the lower rear of the air 
compressor frame. 

4.   Slide washer onto the end of bolt which you   

have just pushed through the air compressor 
frame.

5.   Securely tighten bolt in place with the wheel nut.
6.   Repeat steps 2 through 6 for remaining wheel.

3

!

!

wARNING

Tank Drain Valve should always be opened  

slowly to avoid damage to equipment and 

possible injury.

Air
Chuck

Air 
Regulator

Tank Drain Valve

(not visible in photo)

Safety
Valve

Air Tank

Power 

Switch

Pressure
Gauges