ENGLISH
5
141209
ENGLISH
5
1410162
11.
CHECK FOR DAMAGE.
Check your tool regularly. If part of the tool is damaged it should be
carefully inspected to make sure that it can perform its’ intended
function correctly. If in doubt, the part should be repaired. Refer all
servicing to a qualified technician. Consult your dealer for advice.
12.
STORE IDLE TOOLS
out of the reach of children and untrained persons. Tools may be
dangerous in the hands of untrained users.
13.
MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean. Properly maintained tools, with sharp
cutting edges, are less likely to bind and are easier to control.
14.
NEVER EXCEED THE PRESSURE RATING OF ANY COMPONENT
IN SYSTEM.
15.
PROTECT MATERIAL AND AIR LINES FROM DAMAGE OR
PUNCTURE.
Keep hose and power cable away from sharp objects, moisture,
chemicals, oil, etc.
16.
CHECK CONDITION OF HOSES BEFORE EACH USE.
Do not use a damaged hose. If hose is damaged, replace immediately.
17.
READ, UNDERSTAND AND COMPLY WITH ALL WARNING
LABELS ON UNIT.
18.
DRAIN TANK OF MOISTURE AFTER EACH USE.
If Compressor is not to be used for extended periods of time, leave
tank drain valve open to allow moisture to completely drain from tank.
19.
DO NOT TAMPER WITH SAFETY VALVE.
The Safety Valve is factory set for your model air compressor. Any user
adjustments to Safety Valve will automatically void warranty.
20.
AIR COMPRESSORS GET HOT WHILE IN OPERATION.
Never touch the motor, discharge tubing or compressor pump while in
operation.
21.
THE COMPRESSOR OPERATES AUTOMATICALLY WHILE THE
motor is turned on.
22.
COMPRESSED AIR FROM THE UNIT MAY CONTAIN CARBON
MONOXIDE.
Air produced is not suitable for breathing purposes.
23.
ALWAYS USE A RESPIRATOR WHEN SPRAYING PAINT OR
CHEMICALS.
24.
THE AIR PRESSURE SWITCH IS SET AT THE FACTORY
for optimum performance of your equipment. Never attempt to bypass
or remove this switch as serious damage to equipment or personal
injury could result from excessive air pressure.
Total Extension Cord Length
Amp Rating
Feet
Meters
Feet
Meters
Feet
Meters
Feet
Meters
25
8
50
15
100
30
125
40
3-10 amp
18 ga.
16 ga.
14 ga.
14 ga.
10.1 - 12 amp
16 ga.
16 ga.
14 ga.
14 ga.
12.1 - 16 amp
14 ga.
12 ga.
Not Recommended
Use only UL or CSA approved extension cords
Summary of Contents for AC1106
Page 12: ...ENGLISH 12 SCHEMATIC DRAWING...
Page 13: ......
Page 14: ......
Page 28: ...FRAN AIS 28 SCH MA...
