26776 Simpatica Circle • Lake Forest, CA 92630 • +1-949-581-4464 • Fax +1-949-581-1151
www.generalmonitors.com • email: sales@generalmonitors.com
M
ODEL
2602A
Fault Code
Description
Corrective Action
F7
EEPROM Verification
Failure. This fault will occur
if the microprocessor can
not store calibration or setup
information in the EEPROM.
If this fault occurs consult the factory or
your GMI Representative.
F8
Failed to Complete Setup.
This fault may occur during
or immediately after the
Setup Mode.
Press the Master Reset button to clear
this fault (the previous values for the
setup options will be valid).
F9
Calibration Check Period
Exceeded.
Remove the gas and allow the sensor to
see clean air for at least five minutes.
In each of the fault cases listed on this page, when the fault occurs the FUA output is activated. Pressing
the ACCEPT button on the Facilities Module (FM002A) will acknowledge the fault, de-activate the FUA
output and the fault LED will stop flashing and remain ON until the fault is corrected.
