Models FL3100/3101
10
Figure 3-J Terminal Block Operation
Terminal Connections
All wire connections are made through the base entries to the terminal block (see
Figure 3-J). The terminal block accepts 14 AWG to 22 AWG (2.1 to 0.3mm
2
)
stranded or solid core wire. Each wire should be stripped to .25” (.64cm). To
connect the wire to the terminal block, insert the conductor into the connection
space as shown in Figure 3-J and tighten the corresponding screw terminal.
There are twenty terminal connections. The following pages contain descriptions
and specifications for each connection.
WARNING - Relay contacts must be protected against transient and over-voltage
conditions (see Figure 3-K below).
Figure 3-K Protection Circuits for Relay Contacts
