Maxi-Rooter™
7
TO REMOVE DRUM
1. Remove belt guard by loosening the knob above the motor.
2. Press down on motor and slide V-Belt off of drum.
3. Remove the cutter and connecting screw from the cable end.
4. Unscrew knob behind the front post and pull Power Cable Feed
off the machine. (If your Maxi-Rooter does not have a Power
Cable Feed, loosen the hex head bolts behind the front post cap,
then slide the cap forward off the machine.)
5. Loosen knob on rear drum shaft clamp and move to side, then
swing clamp open.
6. Lift drum clear of machine.
TO INSTALL DRUM
1. Hang V-Belt from motor pulley.
2. Place drum on the machine, positioning the shaft into rear drum
clamp first. Rotate the drum until the hole in the shaft fits over
the guide pin in the clamp.
3. Then put the distributor tube into the front post clamp.
4. Slide Power Cable Feed onto feed post guide pins, allowing the
cable to pass through the feed rollers.
5. Tighten knob on stud protruding through the back of front post. (If
your Maxi-Rooter does not have a Power Cable Feed, slide the
front post cap onto the hex head bolts, then tighten them.)
6. Slip the V-Belt under drum. To make it easier to put the V-Belt in
place, press down on the motor and slide a screw driver, or simi-
lar object into the hole in the motor support guide tube below the
back of the motor. This will keep the motor support spring de-
pressed so that it will be easy to slip the V-Belt around the drum.
After V-Belt is in place, depress the motor enough to pull out
screwdriver.
7. Replace belt guard and tighten knob on top of motor.
DISCONNECT MACHINE FROM POWER SOURCE BE-
FORE REMOVING DRUM FROM MACHINE!
DISCONNECT MACHINE FROM POWER SOURCE
BEFORE INSTALLING DRUM ON MACHINE!
DISCONNECT MACHINE FROM POWER SOURCE
BEFORE INSTALLING CABLE IN DRUM!
Note:
The cable should lay in the drum in a
clockwise direction.
TO INSTALL CABLE IN DRUM
1. Connect the male end of cable to the drum connecting cable
already attached to drum.
2. Remove V-Belt
3. Turn drum clockwise with one
hand while pushing cable into
drum with other hand.
4. Be sure cable goes into drum in
clockwise direction as you look
at the front of the machine or
cable will tangle in drum.
5. Replace V-Belt after cable is
installed.
Amdex
Supply
