79
Englis
h
10.2 Equipment overload and reset.
In case of an overload the circuit breaker will switch to the "OFF" position,
disconnecting the voltage output automatically.
In case of overload, first unplug any plugged equipment.
Once the equipment is unplugged, push up the circuit breaker again by raising the
protector to the "ON" position to restore the power output.
If the circuit breaker trips again after connecting the devices, do not plug the
device. The plugged device may have a problem or exceeds the generator's power.
NOTE
: Once you verify that the generator cannot support or accept the load,
please do not insist. Constant overloads may negatively affect the generator.
Remember that many types of equipment need extra consumption for startup.
Equipment that use motors such as compressors, water pumps, circular saws or
others consume up to 3 times more power for startup. For example, a 1000W
water pump will need 3000W to start up; therefore we would need a generator no
less than 3000W.
CIRCUIT BREAKER
