12
Engl
is
h
4.2
Transportation kit assembly
(depending on versions)
Models above 4Kw carry factory
handles which do not require
assembly.
In models below 4Kw (inclusive),
fasten the handle with screws and
bolts as per attached figure.
Attach the handle with the fold
facing outward as shown in the
drawing, this way the handle will
not touch the front of the engine.
The pin or lock allows the handle to
be fastened in the off position.
Fastening the wheels and support feet:
According to the figure below, screw the wheel axles on the machine frame and
fasten with the nuts. Then introduce the wheels in the axles and fasten with the
washer and nut
The machine is equipped with 4 rubber feet. If using the wheels kit can often
remove the 2 feet opposite of the wheels, the machine would be seated for 2
rubber feet on
one side and
wheels
on the other.
However, if the unit is normally in same place usually recommend keeping the 4
rubber feet.
PIN-LOCK
WHEEL AXLE
NUTS
RUBBER FEET
