14
CAUTION:
Never change the brake fluid by your own. Brake fluid is a dangerous substance. Wrong service leads
to a bad function of the brake system and could occur an accident.
THROTTLE VALVE HANDLE CLEARANCE ADJUSTMENT
z
Correct clearance allows throttle vale handle to rotate 2~6mm.
z
To adjust, first loosen the fixing nut, then turn the adjusting nut
to the proper position and securely tighten the fixing nut.
Check Items:
1.
Check the throttle valve cable to see if it can be moved
smoothly from a closed position to a wide open position.
2.
Rotate steering handle from side to side to check if the throttle
valve cable is interfered.
3. Check to see if the throttle valve cable is obstructed by other
cables preventing it from being operated smoothly.
INSPECTION AND MAINTENANCE OF BATTERY
z
This motorcycle is equipped with a maintenance-free type battery, so it is unnecessary to check
and add electrolyte. Have your motorcycle checked by GENERIC Authorized Dealer or Franchised
Dealer should any abnormality is found.
CAUTION:
z
Clean the battery posts with warm water if the posts are eroded and have some white powders
on them.
z
If there is obvious erosion on the terminals, disconnect the cables, then clean the erosion off
with a steel brush or a piece of sandpaper.
z
Install battery cable after cleaning and apply a thin coat of grease on the terminals.
z
Install battery in reverse order of removal.
Negative
Positive
Remove the battery terminals and clean if there are dirt and
corrosion on them.
Battery removal procedures are as follows:
Turn ignition switch “OFF,” and remove negative cable screw firstly
and disconnect the negative cable. Then, remove positive cable
screw and positive cable.
Adjust nut
Lock nut
