12
AIR CLEANER
Clean every 3000KM
（
2000 miles
）
If the air cleaner is clogged with dust, intake resistance will, be increased with a resultant
decrease in power output and an increase in fuel consumption. Check and clean the element
in the following manner.
Remove screw 1 and screw 2
，
take down air cleaner
Unscrew tapping screw 3
，
remove air cleaner cap 4
Fill a washing pan of a proper size with Non-flammable
cleaning solvent. Immerse the air Cleaner in the cleaning
solvent and wash them clean.
Squeeze the cleaning solvent out of the washed element
By pressing it between the palms of both hands: do not
twist
or wring the air cleaner filter core element or it will
develop tears.
，
Immerse cleaned filter core of air cleaner in CCI or CCI
SUPER oil, and squeeze the oil out of the core
，
which
may be slightly wet with oil.
Install air cleaner filter core in the reverse order of
removal.
CAUTION
：
Before and during the cleaning operation, inspect the core
for tears. A tore core must be replaced
Be sure to position the filter core, so that no incoming air will
bypass it. Remember, rapid wear of piston rings and
cylinder bore is ofter caused by defective or poorly fitted
filter core.
А
Non-flammable cleaning solvent
Б
CCI or CCI SUPER oil
THROTTLE CABLE
Adjust at initially 1000KM
（
600 miles
，
2 months
），
and
every 6000 km
（
4000 miles
，
12 months
）
Loosen locknut
，
and adjust throttle cable play by turning
adjuster in or out to obtain the following cable play. After
adjusting the calbe play
，
tighten the locknut.
Cable play
：
0.5-1.0MM
（
0.02.-0.040 inch
）
Engine idle speed
Adjust at initially 1000KM
（
600 miles
，
2 months
）
and
every 6000 km
（
4000 miles
，
12 months
）
thereafter.
Adjust the throttle cable play.
warm up the engine.
Note
：
Warm up engine for 10 minutes.
Connect an electric tachometer to the connecting protion of the
magneto lead wire as shown in the illustration. Use the selector
key “C’ position.
2
4
1
3
Summary of Contents for XOR 50 ccm
