5
PRECAUTIONS AND GENERAL INSTRUCTIONS
Correctly abide by the following items when disassembling and assembling scooter:
□
Don’t run engine indoors without ventilation;
□
Be sure to replace new bushings, circlips, O-rings and cotter pins with new ones
；
CAUTION
It is forbidden to use the circlip removed from shaft, only use new one
；
Be very carefull to install new circlip for fear that the end hatch of circlip exceeds
required sliding surface for shaft
；
After installing circlip, inspect whether it has been completely clipped into the
groove.
□
Fix bigger diameter bolt first when tightening cylinder head or cylinder, and tighten
to specified torque gradually from inside to outside at diagonal order.
□
Use special tools for some special requirements
；
□
Use original components and recommended engine oil
；
□
Keep each other’s safety when several persons do
；
□
Inspect looseness and operating state of components after reassembling them.
；
□
Take high care of gasoline, which is explosive, and never use gasoline as lotion.
The words like warning, notice, note may turn out incessantly in the manual,
which means:
WARNING
The personal safety of the rider may be involved. Disregarding the
information could result in injury to the rider.
CAUTION
These instructions point out special service procedures or
precautions that must be followed to avoid damaging the machine.
NOTE
it provides some special information, which keeps maintenance
easier and important instructions clearer..
REPLACEMENT COMPONENTS
Be sure to use genuine GENERIC components or their equivalent.. Genuine
GENERIC components are high quality parts which are designed specially for
GENERIC vehicle.
CAUTION
Damage to the scooter may result from use of replacement components which are
not
Equivalent in quality to genuine GENERIC parts, and it can lead to performance
problems.
Summary of Contents for XOR 50 ccm
