Manual
Operating Instructions
Be sure to place the cutter on a flat and even surface when in use.
Do not use excessive force on the cutter or tiles.
After you cut tiles be alert that the newly cut edge will be sharp.
This tile cutter has a two break bar, for angle cuttings and large size or particularly hard tiles,
advantageously use the wide break bar. For narrow cuts use the small break bar.
Please loosen the locked screw to release the carriage before using.
(P5)
1. Small Breaking Device
The small breaking device can be used directly after cutting the tile. (P5)
We recommend using the small breaking device for thin cuts up to 10mm.
2. Big Breaking Device
For long, diagonal and thick/large tiles we recommend the big breaking
device for Optimal results.
To use the big breaking device, pull the carriage back and turn the
breaking device down, then exert a short and forceful push onto the
push bar towards the head of the tile. (P6)
(P6)
We recommend using the big breaking device for wide cuts and strong tiles.
To Cut a Straight Line
1. Loosen the knob on Try Square and slide the Try Square to the desired cutting position.
Tighten the knob. (P7)
2. Place the tile on the shock absorbing pads and push up against the ruler guide.
3. Using the handle, position the cutting wheel on the rear edge of the tile. Ensure the breaker
bar is in the up position for scoring. (P8)
4. Push the handle forward, applying moderate pressure to the cutting wheel and score the full
length of the tile in one, continuous motion.
