English
8V Lithium-ion Cordless Soldering Iron
Operator’s Manual GLSI08B
•
Store idle tool out of reach of children and other inexperienced persons
.
It is
dangerous in the hand of untrained users.
•
Maintain power tools with care
.
Check for proper alignment and binding of moving parts,
component breaks, and any other conditions that may affect the tool’s operation. A guard or any other part that
is damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal
injury.
•
Use recommended accessories
.
using accessories and attachments not recommended by the
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator’s manual for recommended accessories.
•
Never leave the tool running unattended, turn the power off
.
Do not leave the tool
until it comes to a complete stop.
BATTERY TOOL USE AND CARE
•
Ensure the switch trigger is in the off position before inserting battery pack.
Inserting the battery pack into a power tool that have the switch on invites accidents.
•
recharge only with the charger specified by the manufacturer.
A charger that is
suitable for one type of battery pack may create a risk of fire when used with another battery pack.
•
Use battery tools only with specified battery packs
. use of any other battery packs may
create a risk of injury and fire.
•
Avoid storing the battery pack in a container with other metal objects such
as nails, coins, clips, keys, screws, or other small metal objects that can
make a connection from one terminal to another
. Always protect the battery terminals
when battery pack is not being used. Connecting the battery terminals together may cause burns or a fire.
•
Under abusive conditions, liquid may be ejected from the batter
y. Avoid contact.
If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
•
Battery tools do not need to be plugged into an electrical outlet
, therefore, they are
always in operation condition. Be aware of possible hazards when not using your battery tool or when changing
accessories. Following this rule will reduce the risk of electric shock, fire or personal injury.
SERVICE
• Have your power tool serviced by a qualified repair person
using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
• Service your power tool periodically.
When cleaning a tool, be careful not to disassemble any
portion of the tool since internal wires may be misplaced or pinched.
WArNING:
rEAD AND UNDErSTAND ALL WArNINGS, CAUTIONS AND
OPErATING INSTrUCTIONS BEFOrE USING THIS EQUIPMENT. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
EXTENSION COrDS
Grounded tools require a three wire extension cord
.
Double insulated tools can use
either a two or three wire extension cord. As the distance from the power supply outlet increases, you must use a
heavier gauge extension cord. using extension cords with inadequately sized wire causes a serious drop in voltage,
resulting in loss of power and possible tool damage. Refer to the table shown below to determine the required
minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. For example: a 14-gauge cord can
carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total length,
be sure each cord contains at least the minimum wire size required. If you are using one extension cord for more
than one tool, add the nameplate amperes and use the sum to determine the required minimum wire size.
4
