ii
EN.800.003-V2.11(2)
SV-16 v2 Quick Start Guide
Copyright notice
© 2013 Genetec Inc. All rights reserved.
Genetec Inc. distributes this document with software that includes an end-user
license agreement and is furnished under license and may be used only in
accordance with the terms of the license agreement. The contents of this
document are protected under copyright law.
The contents of this guide are furnished for informational use only and are
subject to change without notice. Genetec Inc. assumes no responsibility or
liability for any errors or inaccuracies that may appear in the informational
content contained in this guide.
This publication may not be copied, modified, or reproduced in any form or for
any purpose, nor can any derivative works be created therefrom without Genetec
Inc.’s prior written consent.
Genetec Inc. reserves the right to revise and improve its products as it sees fit.
This document describes the state of a product at the time of document’s last
revision, and may not reflect the product at all times in the future.
In no event shall Genetec Inc. be liable to any person or entity with respect to any
loss or damage that is incidental to or consequential upon the instructions found
in this document or the computer software and hardware products described
herein. The use of this document is subject to the disclaimer of liability found in
the end-user license agreement.
“Genetec”, “Omnicast”, “Synergis”, “Synergis Master Controller”, “AutoVu”,
“Federation”, the Genetec stylized “G” and the Omnicast, Synergis and AutoVu
logos are trademarks of Genetec Inc., either registered or pending registration in
several jurisdictions.
“Security Center”, “Security Center Mobile”, “Plan Manager”, and the Security
Center logo are trademarks of Genetec Inc.
Other trade names used in this document may be trademarks or registered
trademarks of the manufacturers or vendors of the respective products.
All specifications are subject to change without notice.
Document information
Document title: SV-16 v2 Quick Start Guide
Document number: EN.800.003-V2.11(2)
Document update date: August 14, 2013
You can send your comments, corrections, and suggestions about this guide to
documentation@genetec.com
.
