12
Programming fixtures (Either mode) (Example)
In this example, the fixtures to be programmed are 4x 3 channel scanners.
Creating scenes
Mode of controller switched to program mode by pressing pink ‘mode’ button repeatedly until
‘Prog’ appears in the display.
Scenes are to be stored in Band 1 of Chase 1.
P1 held down until ‘Band’ appears in the display.
Up/down buttons are pressed until B1:00 is located.
P1 held down again until ‘ScEn’ appears in the display.
Up/down buttons are pressed until B1:01 is located.
The pan, tilt and colour/gobo is adjusted using the sliders and joystick.
‘Enter’ button pressed to store position settings into B1:01.
Up/down buttons are pressed until ‘B1:02’ is located.
Sliders and joystick are adjusted.
‘Enter’ button pressed to store new position settings into ‘B1:02’.
(repeat until all scenes programmed).
Deleting scenes
Mode of controller switched to program mode (if not already) by pressing pink ‘mode’ button
repeatedly until ‘Prog’ appears in the display.
Scene 20 of Band 2 in Chase 2 is to be deleted.
‘Chase assign’ button pressed repeatedly until Chase 2 light is lit.
P1 held down until ‘Band’ appears in the display.
Up/down buttons are pressed until ‘B2:00’ is located.
P1 held down until ‘ScEn’ appears in the display.
Up/down buttons are pressed until ‘B2:20’ is located.
Left blue button held down for over 2 seconds, until ‘dEle’ appears in display.
Release left blue button. Scene is deleted, and Scene 21 becomes Scene 20.
Note: When you delete a scene, its space in memory is deleted, as well as the scene
settings. Therefore, deleting scene 2 of 32 in a band will mean that there will now be 31
scenes in the band, rather than 32, as one has been deleted. If you continue deleting scenes
in the band, the total number of usable scenes in the band will decrease. New scenes will
need to be inserted by pressing the orange P2 ‘Insert’ button for over 2 seconds (see
‘programming functions’, earlier in this manual) to create a new scene between two selected
existing ones.
Running a light show (Either mode) (Example)
Switch to either Auto or Music mode by pressing the pink ‘mode’ button repeatedly until
either ‘Auto’ for Auto (patterns switched to specified time settings) or ‘MuSc’ for Music
(patterns switched to beat of music).
Band 3 of Chase 1 is to be performed.
P1 held down for over two seconds and released repeatedly until ‘ScEn’ appears in display.
This symbolises that all scenes in a band are to be performed.
‘Chase assign’ button is pressed until Chase 1 is selected.
Up and down buttons either side of display are pressed until Band 3 is selected (B3:00) is
seen in display).
‘Page’ button pressed until all five numbered lights are flashing red.
Summary of Contents for DM4 DigiMaster
Page 1: ...1 V2 0 ...
