Section 4 • Repair Procedures
4 - 22
GR-20J • GR-26J
Part No. 227656
September 2016
MAST COMPONENTS
8 Using Illustration 1 as a guide, tag and remove
the outer wear pads and shims from the bottom
of the number 2 mast section. Set the shims to
the side. Discard the wear pads.
Note: For ease of mast reassembly, make careful
note of the location, order and orientation of the
shims.
Note: Use a hammer and chisel if necessary to
gently loosen the wear pads from the mast.
9 Using Illustration 1 as a guide, tag and remove
the outer wear pads and shims from the bottom
of the number 1 mast section. Set the shims to
the side. Discard the wear pads.
Note: For ease of mast reassembly, make careful
note of the location, order and orientation of the
shims.
Note: Use a hammer and chisel if necessary to
gently loosen the wear pads from the mast.
10 Using Illustration 1 as a guide, tag and remove
the inner wear pads and shims from the top of
the number 1 mast section. Set the shims to the
side. Discard the wear pads.
Note: For ease of mast reassembly, make careful
note of the location, order and orientation of the
shims.
Note: Use a hammer and chisel if necessary to
gently loosen the wear pads from the mast.
How to Assemble the Mast,
GR-20J
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting this
procedure without these skills and
tools could result in death or
serious injury and significant
component damage. Dealer
service is strongly recommended.
1 Using Illustration 1 as a guide, install two 10
mm wear pads, and the corresponding shims
removed in the mast disassembly process, onto
the bottom of mast sections 1 and 2.
Illustration 1
a
wear pad 10 mm
b
mast section (mast 1 shown)
P
a
b
TOP
BOTTOM
a
