Genie GS-2032, Operator'S Manual

Part No. 46281

Genie GS-2032 & GS-2632 & GS-2046 & GS-2646 & GS-3246

19

Operator's Manual

First Edition • Seventeenth Printing

FUNCTION TESTS

32

Press the drive function select switch.

Move the lift/drive selector switch to
the drive position (if equipped).

33 Press and hold the function enable switch on the

control handle. Slowly move the control handle
to the full drive position.

Result: The maximum achievable drive speed

with the platform raised should not exceed
0.75 feet per second / 23 cm per second.

If the drive speed with the platform raised exceeds
0.75 feet per second / 23 cm per second,
immediately tag and remove the machine from
service.

Test the Tilt Sensor Operation

Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.

34 Fully lower the platform.

35 Place a 2x4 or similar piece of wood under both

wheels on one side and drive the machine up
onto them.

36 Raise the platform approximately 7 feet / 2.1 m

from the ground.

Machines produced before 01-01-02:

Result: The tilt alarm will sound at 600 beeps

per minute.

CE and Australia models: The drive function and

the lift function will not operate.

Proceed to step 38.

Test Drive and Braking

27 Press and hold the function enable switch on the

control handle.

28 Slowly move the control handle in the direction

indicated by the blue arrow on the control panel
until the machine begins to move, then return
the handle to the center position.

Result: The machine should move in the

direction that the blue arrow points on the
control panel, then come to an abrupt stop.

29 Slowly move the control handle in the direction

indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.

Result: The machine should move in the

direction that the yellow arrow points on the
control panel, then come to an abrupt stop.

Note: The brakes must be able to hold the machine
on any slope it is able to climb.

Test Limited Drive Speed

30

Press the lift function select button.

Press and hold the lift function enable
button.

Move the lift/drive selector switch to
the lift position (if equipped).

31 Press and hold the function enable switch on

the control handle. Raise the platform
approximately 4 feet / 1.2 m from the ground.

Result: The pothole guards should deploy.