Service and Repair Manual
November 2016
Steer Axle Components
72
GS-2669 DC • GS-3369 DC • GS-4069 DC
Part No. 1272220GT
12 Remove the retaining fastener from the lower
yoke king pin.
13 Use a small pry bar to remove the king pin.
14 Remove the retaining fastener from the upper
yoke king pin.
15 Use a small pry bar to remove the king pin.
16 Remove the yoke assembly from the machine.
Crushing hazard. The assembly
may become unbalanced and fall if
not properly supported and
secured with a suitable lifting
device when it is removed from the
machine.
Right side yoke:
17 Remove the steer cylinder rue ring and clevis
pin from the yoke and set aside.
18 Remove the tie rod rue ring and clevis pin from
the yoke and set aside.
19 Remove the retaining fastener from the lower
yoke king pin.
20 Use a small pry bar to remove the king pin.
21 Remove the retaining fastener from the upper
yoke king pin.
22 Use a small pry bar to remove the king pin.
23 Remove the yoke assembly from the machine.
Crushing hazard. The assembly
may become unbalanced and fall if
not properly supported and
secured with a suitable lifting
device when it is removed from the
machine.
How to Remove a Drive Motor
Component damage hazard.
Repairs to the motor should only
be performed by an authorized
dealer.
Component damage hazard. The
work area and surfaces where
this procedure will be performed
must be clean and free of debris
that could get into the hydraulic
system and cause severe
component damage. Dealer
service is recommended.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications,
Hydraulic Hose and Fitting Torque
Specifications.
1
Refer to Repair Procedure,
How to Remove
the Yoke
.
2
Remove the drive motor mounting fasteners.
Remove the drive motor from the yoke.
