Second Edition • Second Printing
Operator's Manual
Inspections
Part No. 1278002GT
GS
™
-2669DC • GS
™
-3369DC • GS
™
-4069DC
29
Test the Drive Function Button
Use this function test procedure if the decal on your
platform controls has these buttons.
51 Press the drive function button (if
equipped).
52 Wait seven seconds for the drive function to
time out.
53 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: No functions should operate.
Test the Steering
Note: When performing the steer and drive function
tests, stand in the platform facing the steer end of
the machine.
54 Press the drive function button (if
equipped).
55 Press and hold the function enable switch on
the control handle.
56 Press the thumb rocker switch on top of the
control handle in the direction indicated by the
blue triangle on the control panel.
Result: The steer wheels should turn in the
direction indicated by the blue triangle.
57 Press the thumb rocker switch on top of the
control handle in the direction indicated by the
yellow triangle, on the control panel.
Result: The steer wheels should turn in the
direction indicated by the yellow triangle.
Test Drive and Braking
58 Press the drive function button (if
equipped).
59 Press and hold the function enable switch on
the control handle.
60 Slowly move the control handle in the direction
indicated by the blue arrow on the control panel
until the machine begins to move, then return
the control handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop
when the control handle is returned to the
center position.
61 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the control handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop
when the control handle is returned to the
center position.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
Summary of Contents for GS-2669DC
Page 59: ......
