August 2018
Part No. 57.4400.9220GT
GTH-2506 GTH-3007
4-21
Section 4 • Repair Procedures
Axle
5-1
Disabled Machine
How to Move a Disabled
Machine
WARNING
Tow the machine only when no
alternative is possible, since this
operation may result in serious
damage to the transmission.
When possible, repair the
machine on site.
When the machine shall absolutely be towed and
the front axle can be lifted:
1 Chock the wheels.
2 Remove the fasteners securing the driveshaft
to the axle. Remove the driveshaft from the
machine.
3 Remove the chocks from the wheels.
4 Unlock the parking brake.
5 Select two wheel steer mode.
6 Set the transmission lever in the neutral
position.
7 Raise the front wheels of the machine.
WARNING
Tow the machine for short
distances and at a low speed
only (less than 3 mph).
When the machine shall absolutely be towed and
the front axle can NOT be lifted:
1 Use a rigid drawbar.
2 Unlock the parking brake.
3 Select two wheel steer mode.
4 Set the transmission lever in the neutral
position.
5 Unlock the negative brake as described on the
next page.
6 If the
towing distance is less than 164 ft /
50m
, disconnect the high pressure hoses "d"
between pump and hydraulic motor.
WARNING
Tow the machine at a low
speed only (less than 1.85 mph
/ 3 km/h). The motor can be
damaged if it runs without oil for
a greater distance.
d
d
