Document 57.0005.8200 - 12/2005
Handler with telescopic boom
GTH-6622
Page
D-16
MAINTENANCE
■
D-3.12
OIL LEVEL IN THE (front/rear) WHEEL
REDUCTION GEARS
To check the oil level within the wheel reduction gears:
•
Stop the machine on a level ground and ensure the
parking brake is engaged and plug
finds on the
horizontal axis.
•
Clean the plug all around, then remove it and check
if oil is level with the hole.
•
If necessary, add new oil through hole
until it is
level.
•
Refit the plug.
For the oil change:
•
Stop the machine and ensure the plug is oriented
along the vertical axis.
•
Place a container of suitable size under the reduction
gear plug.
•
Unscrew plug
and drain any oil from the reduction
gear.
•
Rotate the wheel by 90° until the plug finds again
on the horizontal axis.
•
Add new oil through hole
.
•
Refit and tighten plug
.
SERVICE INTERVAL
Running-in _________
Within the first
10
hours
Ordinary __________________
Every
250
hours
PROTECT THE
ENVIRONMENT
The handling and disposing of used oils can be
ruled by local or national regulations. Address to
authorised centres.
IMPORTANT
When changing the oil, drain it when it is still hot
and the polluting substances are in suspension.
