12
Jump Start Override
If the vehicle battery voltage is under 2 volts, an extra
step is required to attempt to start the vehicle.
1. Follow the hook-up procedure shown on page 12-13.
2. Press and hold the JUMP START button for 3 seconds. This will
activate a “phantom” polarity check.
NOTE:
This “phantom” polarity check can take up to 30 seconds.
If polarity is reversed, the JUMP START button LED will flash
continuously, reverse the clamps.
3. When JUMP START button LED stops flashing, Attempt to start
vehicle.
NOTE:
If vehicle does not start, allow Genie ReliaVolt™ to rest 10
seconds before attempting to start vehicle again. When the Jump Start
button is green, it is ready for your next attempt. Try this process up to
two additional times with at least 10 seconds in between attempts.
If vehicle fails to start after 3 attempts, discontinue use of the Genie
ReliaVolt™ and seek other methods to start vehicle.
4. Once vehicle has started, press POWER button on the side of unit to
turn OFF.
5. Remove jump starter clamps from vehicle battery.
• Recharge Genie ReliaVolt™ as soon as possible to keep ready.
•
Store Genie ReliaVolt™ in its original case along with these
instructions.
