REV C
June 2005
Section 3 • Scheduled Maintenance Procedures
Part No. 52075
TMZ-34/19
3 - 25
CHECKLIST
D
PROCEDURES
a
b
c
d
D-2
Inspect for
Turntable Bearing Wear
Periodic inspection of turntable bearing wear is
essential to safe machine operation, good machine
performance and service life. Continued use of a
worn turntable bearing could create an unsafe
operating condition, resulting in death or serious
injury and component damage.
Perform this procedure with the
machine on a firm, level surface
and the boom in the stowed
position.
1 Grease the turntable bearing. See A-11, Grease
the Turntable Rotation Bearing and Rotate
Gear.
2 Torque the turntable bearing bolts to
specification. See D-1, Check the Turntable
Rotation Bearing Bolts.
3 Start the machine from the ground controls and
raise the primary and secondary booms to full
height. Do not extend the primary boom.
4 Place a dial indicator between the drive chassis
and the turntable at a point that is directly
under, or inline with, the boom and no more
than 1 inch / 2.5 cm from the bearing.
To obtain an accurate
measurement, place the dial
indicator no more than
1 inch / 2.5 cm from the turntable
rotation bearing.
5 At the dial indicator, adjust it to "zero" the
indicator.
a
turntable
b
dial indicator
c
drive chassis
d
turntable rotation bearing
6 Lower the secondary boom to the stowed
position and lower the primary boom to a
horizontal position. Fully extend the primary
boom.
7 Note the reading on the dial indicator.
Result: The measurement is less than
0.025 inch / 0.635 mm. The bearing is good.
Result: The measurement is more than
0.0249 inch / 0.634 mm. The bearing is worn
and needs to be replaced.
8 Fully retract the primary boom. Raise the
primary and secondary booms to full height.
Visually inspect the dial indicator to be sure the
needle returns to the "zero" position.
9 Remove the dial indicator and rotate the
turntable 90°.
10 Repeat steps 4 through 9 until the rotation
bearing has been checked in at least four
equally spaced areas 90° apart.
11 Lower the primary and secondary booms to the
stowed position and turn the machine off.
12 Remove the dial indicator from the machine.
800-610-4101
ActionRental.com
