Quick Start Guide
2 Channel Wiegand Radio Receiver - Up to 30m
6
1.11 6-Pin Terminal Block
Refer to the information below for cabling to the Receiver:
AD0: Button One, Wiegand Data 0, Channel A.
AD1: Button One, Wiegand Data 1, Channel A.
BD0: Button Two, Wiegand Data 0, Channel B.
BD1: Button Two, Wiegand Data 1, Channel B.
GND: Power, 0VDC
+VDC: Power, 12VDC Nominal.
NOTE: Apply positive voltage only to the +VDC Pin on the Terminal Block.
1.12 Connection
Connection must be done in accordance with NFPA 70. Do not connect to a receptacle
controlled by a switch. Connect to a power limited DC voltage source.
1.13 Troubleshooting
No data received/Transmitter not enrolled
Transmitter must be clicked twice to be learned by the Receiver upon initial Receiver
power up
