Operator's Manual
Seventh Edition · First Printing
Part No. 133083
Z-60/34
31
Inspections
45 Retract the primary boom to the stowed position.
46 Raise the secondary boom approximately
61 cm.
47 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 30 cm per second.
48 Lower the secondary boom to the stowed
position.
Note: If the drive speed with the primary boom
raised or extended or the secondary boom raised
exceeds 30 cm per second, immediately tag and
remove the machine from service.
Test the Oscillate Axle
(oscillating axle-equipped models)
49 Start the engine from the platform controls.
50 Drive the right steer tire up onto a 15 cm block
or curb.
Result: The three remaining tires should stay in
firm contact with the ground.
51 Drive the left steer tire up onto a 15 cm block or
curb.
Result: The three remaining tires should stay in
firm contact with the ground.
52 Drive both steer tires up onto a 15 cm block or
curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Test Auxiliary Controls
53 Shut the engine off.
54 Pull out the red Emergency Stop button to
the on position.
55 Press down the foot switch.
56 Simultaneously hold the auxiliary power switch
on and activate each function control handle or
toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive functions should not operate with
auxiliary power.
Test the Lift/Drive Select Function
(if equipped)
57 Press down the foot switch.
58 Move the drive control handle off center and
activate a boom function toggle switch.
Result: No boom functions should operate. The
machine will move in the direction indicated on
the control panel.
59 Repair any malfunctions before operating the
machine.
