Operator's Manual
Sixth Edition • Sixth Printing
Inspections
32 Z-80/60
Part No. 226482
At the Ground Controls
1
Select a test area that is firm, level and free of
obstruction.
2
Turn the key switch to ground control.
3
Pull out the red Emergency Stop button to the
on position.
Result: The LCD screen will come on and
display no error messages. The beacon (if
equipped) should flash.
Note: In cold climates, the LCD readout screen will
need to warm up before the display appears.
4
Start the engine. See Operating Instructions
section.
Test Emergency Stop
5
Push in the red Emergency Stop button to the
off position.
Result: The engine should shut off and no
functions should operate.
6
Pull out the red Emergency Stop button to the
on position and restart the engine.
Test Machine Functions
7
Do not press and hold
a function
enable/speed select
button. Attempt to
activate each boom
and platform function
button.
Result: No boom and platform functions should
operate.
8
Press and hold a function enable/speed select
button and activate each boom and platform
function button.
Result: All boom and platform functions should
operate through a full cycle. The descent
alarm should sound while the boom is
lowering.
Test Emergency Controls
9
Turn the key switch to ground control and shut
the engine off.
10
Pull out the red Emergency Stop button to the
on position.
11
Simultaneously hold the
emergency power switch
on and activate each boom
function toggle switch.
OR
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom functions should operate.
Test the Tilt Sensor
12
Press one of the LCD
screen control buttons until
TURNTABLE LEVEL
SENSOR X-DIRECTION
appears.
Result: The LCD screen should display the
angle in degrees.
13
Press the LCD screen control buttons until
TURNTABLE LEVEL SENSOR Y-DIRECTION
appears.
Result: The LCD screen should display the
angle in degrees.
14
Press the LCD screen control buttons until
PLATFORM LEVEL SENSOR DEGREES
appears.
Result: The LCD screen should display the
angle in degrees.
Summary of Contents for Z-80/60
Page 8: ...Operator s Manual Sixth Edition Sixth Printing Personal Safety 6 Z 80 60 Part No 226482...
Page 10: ...Operator s Manual Sixth Edition Sixth Printing Personal Safety 8 Z 80 60 Part No 226482...
Page 43: ...Sixth Edition Sixth Printing Operator s Manual Inspections Part No 226482 Z 80 60 41...
