Step 2. Run SETUP Program
To run SETUP program in the DOS prompt, please locate
the prompt under A:\SETUP subdirectory and type:
A:>SETUP
[J]
To configure the LAN adapter, please select “Configuration”
and
and the program begins.
provides auto-configuration function. By selecting
this function, the program will automatically detect the
available IRQ and I/O, and avoid the potential conflicts in the
systems.
Users may configure the adapter by selecting “Manual
Setup”. The “*” mark shown in the menu means that there is
a potential conflict, and you can not use that address.
Figure 7. Manual Setup
2-2
After comoletina the setuo oroaram. users MUST select
“Save Configuration” to save the selection and reboot PC
system again by truning OFF/ON power switch.
Jumper Mode Configuration
If jumper configuration is used, the following jumper settings
1
(JP1 and JP2) are required:
I. JP1 Setting (IRQ Setting)
Remove jumper from “JPLESS” position and put it to the
IRQ position which is selected.
Figure 8. IRQ Jumper setting
II. JP2 Setting (I/O, Boot ROM, Memory address setting)
I/O Address Setting
GE200011 is factory-set to use l/O address 300H. If address
300H is occupied by other hardware, please change the
setting on JP2 to another address. The figure below shows
the settings.
Figure 9. I/O Jumper setting
2-3