ENGLISH
Genius Car Alarm
www.geniuscaralarm.com
34
* Example to do the Programming:
a. Select the functions to be changed. (It is recommended to write down them to avoid
mistakes)
b. If you are going to work with 2 or 3 functions, follow these steps:
c. Function # 2: Press valet switch twice and then select
button 1
.
d. Then, if you wish to program, function #4, press twice again the valet switch (to
complete the # 4) then select
button 2
of the remote control.
e. And then, if you also want to program function # 8, press four times the valet switch (to
complete the # 8), select the
button 2
of the remote control.
IMPORTANT: Going from one function to another, just press the valet switch the
number of times necessary to complete the following function.
DETAILS OF THE PROGRAMMING FUNCTIONS
1. LOCK CLOSURE WITH AUTOMATIC ARM
If we programmed the Automatic Arming function (JUMPER 1), the alarm will arm by itself,
so with this function 1 we can choose to unlock or lock the doors.
2. DOORS’ SIGNAL ARMING DELAY
This function allows us to arm the alarm even when the dome lights are on, because the
system will not recognize this signal for the programmed time, avoiding notices of open
door when the alarm is armed.
3. ANTI-HIJACKING BY TRANSMITTER
This function is used to immobilize the vehicle in case of emergency; pressing the buttons
1 and 2 simultaneously for 3 seconds while the engine is running, the siren will chirp once
and the parking lights will flash once; after 15 seconds, the LED will start to twinkle
indicating the activation of the anti-hijacking mode. This function is programmable (See
Functions Programming Table)
4 and 5 DOORS LOCK WITH IGNITION
This function provides us comfort and security. When the engine is turned on, the doors
will
lock
TWO seconds later. When the engine is turned off, the doors will unlock
immediately.
6. OUTPUTS FOR CHANNEL 3
Select a function from one of these three options:
1. CHANNEL 3- Output to drive an optional function, such as a windows module.
2. SECOND PULSE TO UNLOCK DOORS
3. HORN OUTPUT-
*
NEGATIVE OUTPUT *
7. ANTI-HIJACKING WARNING:
BEGINNING OF THE SEQUENCE
When this function is activated, triggering the anti-hijacking will make the siren chirp once.
8. ARMING OR DISARMING WARNINGS
When arming the alarm, the siren will chirp once; when disarming the alarm, the siren will
chirp three times. Sometimes, the chirps may be annoying, so the system gives us the
option to cancel temporarily these warning sounds.
9. REMINDER TO ARM THE ALARM
When we get off the vehicle and close the last door,
5
seconds later the siren will chirp
three times and
10
seconds later other three chirps will be produced, indicating that we
have not armed the alarm.