4. If the connection is OK, the following window will be displayed:
A
A
l
l
i
i
g
g
n
n
i
i
n
n
g
g
t
t
h
h
e
e
S
S
c
c
a
a
n
n
n
n
e
e
r
r
In most cases, the scanner doesn’t need to be aligned but there are instances
when the alignment might be required. You need to align the scanner only if parts of
the scanned document are missing from any of its edges. For example, the heading of
a document might be missing from the top edge after the document has been scanned.
To align the scanner, follow the steps below:
1. Place a photograph on the top right side of the scanner glass (near the back
of the scanner). Please note that only part of the photograph will be scanned.
2. Click on the SCAN button
. Part of the photograph will be displayed
in the ALIGNMENT window.
3. Click on the ALIGN POSITION buttons until the top left corner of the scanned
photograph aligns with the top left corner of the preview window.
4. Click on the check mark button
when the alignment has been
completed.
L
L
a
a
m
m
p
p
C
C
o
o
n
n
t
t
r
r
o
o
l
l
The scanner’s lamp may be turned ON and OFF manually in the Scanner Utility
program. While there, you can also set a timer to turn the lamp off after the scanner
has been idle for a designated amount of time.
To do this, click on the Windows START button and choose PROGRAMS, Genius
Scanner (the model name of your scanner), SCANNER UTILITY. In the window that
opens, find the Lamp Control section shown below:
Click on the On/Off switch at the far right of the section to immediately turn the
scanning lamp on or off.
You may also set the default time for the lamp to automatically turn off after a
scan by clicking the up or down arrows next to the area that reads “minutes to turn off
lamp.”
Genius Scanner
18
