ENGLISH
Genius Car Alarm
www.geniuscaralarm.com
25
4. If you wish to program a second transmitter, repeat step 3 where the siren confirms
with 2 sounds the memorization of the second transmitter and with 3 sounds the
third and with 4 the programming ends.
The system pre-programmed with a routine of work with each button of the Transmitter. It works
with the following configuration:
a. Alarm is armed and the doors
are locked
a. IGNITION IS
OFF
Press
button 1
once
b. Stop temporarily the alarm’s
trigger
b. SIREN
SOUNDING
Press
button 1
, then
button
3
within 2 seconds
Arm the alarm cancelling the
ultrasonic sensor.
IGNITION IS OFF
Press
button 1,
then
button
2
within 2 seconds
Arm the alarm cancelling the
ultrasonic sensor and the doors’
signal input
IGNITION IS OFF
Disarm and unlock doors
ARMED
Press
button 2
once
Stop temporarily the alarm’s
trigger.
SIREN
SOUNDING
Press
button 4
for 3 seconds Channel 2 (Open Trunk)
IGNITION IS OFF
Press
button
1
for 1 second
Car Finder.
ARMED
Press
button 3
for 3 seconds Panic
IGNITION IS OFF
Press
buttons 1
and
2
together for 3 seconds
Anti-hijacking
IGNITION IS ON
Press
button 3
, then
button
1
within 2 seconds.
Silent Arming Mode
IGNITION IS OFF
Press
button 3
, then
button
2
within 2 seconds.
Silent Disarming Mode
ARMED
Press
button
4
, then
button
3
for 3 seconds.
Valet Mode
IGNITION IS OFF
Press
buttons 3
and
4
together for 2 seconds.
Arm Channel 3
IGNITION IS
ON/OFF
Alarm system armed.
The alarm system can be armed in 2 methods.
1. The first, using button I on the transmitter. It is necessary for the ignition switch to
be OFF and for the system not to be on Valet.
2.
The second, using the automatic armed, which is obtained when the ignition switch
goes from ON to OFF and then open and close a door. The system will
automatically arm in 30 seconds after closing the last door, this functions is
programmable (see function programming chart)
